FEP65X72 Pallet Fork Extensions | 72 inch for 5 inch Forks

Description

The FEP65X72 are 72 inch pallet fork extensions for 5 inch forks that need added support beneath longer loads. They slide over compatible existing forklift or loader forks rather than replacing the original blades. The supporting forks must be at least 48 inches long. For operators who occasionally handle deep pallets, lumber bundles, or other suitable long material, this model offers additional fork coverage without keeping a longer fork set mounted for every job.

The extension is 72 inches long overall; that dimension is not the amount of extra length added beyond the original fork. Measure the supporting blade and check the extension’s inside clearance, heel retention, and the equipment manufacturer’s requirements before use. Extensions add reach, but they do not increase the lifting capacity of the machine or base forks.

Size the Extension to the Existing Forks

FEP65X72 is designed for forks 5 inches wide and at least 48 inches long. A 48 inch fork beneath a 72 inch extension meets the product’s stated minimum length; a shorter fork does not. Fork width alone cannot confirm fit, so check blade thickness, taper, any added wear surfaces, and clearance inside the extension. Confirm that both extensions can slide into place and seat behind their respective fork heels.

The open-channel underside makes it possible to slide the extensions over the blades. A heel-retention feature engages behind each fork heel to resist the extensions moving forward. Inspect the retention arrangement and confirm that it is fully seated before lifting. If an extension does not seat correctly, investigate the fit rather than using it with partial engagement.

The extensions can be removed when the standard forks provide enough support. Before installing or removing them, lower the carriage, park the machine as directed by its manufacturer, and check for damage or debris in the channels. Keep the supporting forks properly spaced and verify that the extensions stay aligned when the carriage is raised.

Added Support Without Added Lift Capacity

The 72 inch length may help support deeper pallets, long crates, pipe bundles, or lumber when the load is suitable for fork handling. It does not guarantee that any long or flexible material will remain balanced. Determine the load’s weight and center of gravity, support it appropriately, and consider whether additional restraint or a different attachment is needed.

Extensions place their own weight on the fork system and can allow a load to sit farther from the carriage. That increased load center can reduce the machine’s usable lifting capacity. Consult the machine’s data plate, load chart, and attachment instructions; follow the lowest applicable limit for the machine, carriage, forks, and extensions. The FEP65X72 product page does not state an independent load rating in pounds, so do not assume one based on the extension dimensions.

The steel construction and black powder coat finish are intended for repeated material-handling use. Inspect the extensions for bends, cracked welds, significant wear, or damaged heel-retention parts. Check the underlying forks and carriage at the same time, particularly after moving dense loads or working on rough surfaces. Remove damaged components from service.

These 72 inch pallet fork extensions for 5 inch forks are the shorter of PRO-Link’s two 5 inch width options. For 96 inch extension length, compare the FEP65X96, which requires base forks at least 72 inches long. If your forks are 4 inches wide, review the extension range for a matching model. PRO-Link’s fork extension sizing guide explains the length and fit checks in more detail.

The FEP65X72 is covered by PRO-Link’s one-year limited warranty against manufacturing defects, subject to its terms.

Questions About the FEP65X72

What base fork length is required?

The supporting forks must be at least 48 inches long. They must also fit the extension channels and heel-retention design.

Do these extensions raise my forklift’s capacity?

No. Extensions add weight and can move the load forward, potentially reducing usable capacity. Follow the limits for the complete lifting setup.

Will they fit 4 inch wide forks?

This model is specified for 5 inch wide forks. Choose a compatible 4 inch width model for 4 inch forks.